How to Reset a Liftmaster Garage Door Opener - Method 1
Method1
Accessing the Garage Door Motor
-
1. Set up a ladder beneath the garage door motor in your garage. The garage door motor is a roughly 8 in × 5 in (20 cm × 13 cm) box mounted to the roof of your garage. Open the ladder by pulling the 2 metal halves apart from each other and pressing down on the 2 cross-beams. Then, climb up the ladder until you can comfortably reach the garage door motor.[1]- If you don’t have a ladder, purchase one from a hardware store or a home improvement store. Or, borrow one from a friend.
-
2. Open the panel on the left side of the motor unit. If you’re standing in front of your garage door and looking at the motor unit, the left-hand light compartment doubles as a panel covering the unit’s controls. Pull firmly down on this panel until it comes away from the motor unit. The hinges at the bottom of the panel will allow it to swivel down without falling.[2]- The panel placement may differ from one style of unit to the next. The panel may also be located at the back or side of the garage door motor box.
-
3. Locate the “Learn” button at the front of the control panel. Once you’ve lowered the light panel out of the way, you’ll see a series of warnings and safety information, a light bulb, and a small control panel. Look over the control-panel area until you spot a small button labeled “Learn.” The button will only be about 1⁄2 inch (1.3 cm) in diameter.[3]- Depending on the make and model of your garage door opener, the button may be yellow and round or purple and square.
https://www.wikihow.com/